3/22/2023 0 Comments Mqtt enter deepsleep![]() The program compiles and runs but will not connect to MQTT broker. ![]() I then removed the millisecond timer code that repeated the loop and put all the loop code in Setup then added the deep sleep command at the end of setup. So, there seems to be a difference between entering sleep from rule command and doing it from config menu. I implemented the tutorial as written on a esp8266 D1 mini board and it worked just fine. ![]() But after 20 sec, when it's supposed to wake up again, current goes up to 13mA and device is never booted.! However, when I want the esp to sleep it never wakes up again to send data, but strangely I can. I use Node Red and can send the required messages. These are controlled by a switch from the UI. I have made the suggested implementation using Mqtt using an ON and an OFF message. I would like to be able to send OTA to my node when in deep sleep. When deepsleep command is executed, current goes down to 0.2mA again. Hi Trying to make a weather station for my garden. I have a rule script that on MQTT#Connected, publish the temp on mqtt and then enter deepsleep, 20. I then tested another approach, disabled deepsleep in config menu and in stead entered deep sleep by command in rule set. Sleep/wakeup worked as expected though! I could see with multimeter that during normal operation, current is between 70-80mA and during deepsleep it's down to approx 0.2mA. On another module (SIM7000) where I tried this it would not enter low power mode. ![]() Before we go into deep sleep we must set a wake up input, failing to do so. I want to publish a message every 15 minutes and deep sleep in between. All ESP32 GPIO pins can operate in Input or Output modes. Played around with different awake/sleep times, but could not get a stable result. Deep sleep mode will reduce the power consumption and your batteries will. Mongoose MQTT broker and client already works, including one-click (ok, one CLI-command) AWS. compromise for remote access View geeni camera on computer If you want to. The goal is to boot up, publish temperature on mqtt and then sleep for a couple of minutes and repeat.Īt first, I enabled deepsleep from config menu. Now open the Mosquito MQTT Broker add-on and then click install Power up the. ESP32 sends the signal to enter Deep Sleep mode to the ESP8266 and stops. Running mega-20190116 on a Wemos D1 mini with a ds18b20 connected to gpio-14. connection to the Wi-Fi network, the MQTT server and the Thinger platform. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |